HD6417750RF240V Datasheet, PDF (95/606 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 4 Exception Handling
4.3 Reset
A reset has the highest exception priority.
When the RES pin goes low, all processing halts and this LSI enters the reset. To ensure that this
LSI is reset, hold the RES pin low for at least 20 ms at power-up. To reset the chip during
operation, hold the RES pin low for at least 20 states. A reset initializes the internal state of the
CPU and the registers of on-chip supporting modules.
The chip can also be reset by overflow of the watchdog timer. For details see section 13,
Watchdog Timer.
The interrupt control mode is 0 immediately after reset.
4.3.1 Reset Exception Handling
When the RES pin goes high after being held low for the necessary time, this LSI starts reset
exception handling as follows:
1. The internal state of the CPU and the registers of the on-chip supporting modules are
initialized, the T bit is cleared to 0 in EXR, and the I bit is set to 1 in EXR and CCR.
2. The reset exception handling vector address is read and transferred to the PC, and program
execution starts from the address indicated by the PC.
Figures 4.1 and 4.2 show examples of the reset sequence.
Rev. 7.00 Sep. 11, 2009 Page 59 of 566
REJ09B0211-0700