HD6417750RF240V Datasheet, PDF (155/606 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 8 Data Transfer Controller (DTC)
8.5.4 Chain Transfer
Setting the CHNE bit in MRB to 1 enables a number of data transfers to be performed
consecutively in response to a single transfer request. SAR, DAR, CRA, CRB, MRA, and MRB,
which define data transfers, can be set independently.
Figure 8.8 shows the memory map for chain transfer.
When activated, the DTC reads the register information start address stored at the vector address,
and then reads the first register information at that start address. After the data transfer, the CHNE
bit will be tested. When it has been set to 1, DTC reads the next register information located in a
consecutive area and performs the data transfer. These sequences are repeated until the CHNE bit
is cleared to 0.
In the case of transfer with CHNE set to 1, an interrupt request to the CPU is not generated at the
end of the specified number of transfers or by setting of the DISEL bit to 1, and the interrupt
source flag for the activation source is not affected.
Source
DTC vector
address
Register information
start address
Register information
CHNE = 1
Register information
CHNE = 0
Destination
Source
Destination
Figure 8.8 Chain Transfer Operation
Rev. 7.00 Sep. 11, 2009 Page 119 of 566
REJ09B0211-0700