HD6417750RF240V Datasheet, PDF (400/606 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 14 Serial Communication Interface (SCI)
14.7 Operation in Smart Card Interface
The SCI supports an IC card (Smart Card) interface that conforms to ISO/IEC 7816-3
(Identification Card) as a serial communication interface extension function. Switching between
the normal serial communication interface and the Smart Card interface mode is carried out by
means of a register setting.
14.7.1 Pin Connection Example
Figure 14.21 shows an example of connection with the Smart Card. In communication with an IC
card, as both transmission and reception are carried out on a single data transmission line, the TxD
pin and RxD pin should be connected to the LSI pin. The data transmission line should be pulled
up to the V_CC power supply with a resistor. If an IC card is not connected, and the TE and RE bits
are both set to 1, closed transmission/reception is possible, enabling self-diagnosis to be carried
out. When the clock generated on the Smart Card interface is used by an IC card, the SCK pin
output is input to the CLK pin of the IC card. This LSI port output is used as the reset signal.
TxD
RxD
SCK
Rx (port)
This LSI
Connected equipment
V_CC
Data line
Clock line
Reset line
I/O
CLK
RST
IC card
Figure 14.21 Schematic Diagram of Smart Card Interface Pin Connections
Rev. 7.00 Sep. 11, 2009 Page 364 of 566
REJ09B0211-0700