HD6417750RF240V Datasheet, PDF (129/606 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 6 PC Break Controller (PBC)
6.3.3 Notes on PC Break Interrupt Handling
• When a PC break interrupt is generated at the transfer address of an EEPMOV.B instruction
PC break exception handling is executed after all data transfers have been completed and the
EEPMOV.B instruction has ended.
• When a PC break interrupt is generated at a DTC transfer address
PC break exception handling is executed after the DTC has completed the specified number of
data transfers, or after data for which the DISEL bit is set to 1 has been transferred.
6.3.4 Operation in Transitions to Power-Down Modes
The operation when a PC break interrupt is set for an instruction fetch at the address after a
SLEEP instruction is shown below.
• When the SLEEP instruction causes a transition from high-speed (medium-speed) mode to
sleep mode:
After execution of the SLEEP instruction, a transition is not made to sleep mode, and PC break
interrupt handling is executed. After execution of PC break interrupt handling, the instruction
at the address after the SLEEP instruction is executed (figure 6.2 (A)).
• When the SLEEP instruction causes a transition to software standby mode:
After execution of the SLEEP instruction, a transition is made to the respective mode, and PC
break interrupt handling is not executed. However, the CMFA or CMFB flag is set (figure 6.2
(B)).
SLEEP
instruction execution
SLEEP
instruction execution
PC break exception
handling
Transition to
respective mode
(B)
Execution of instruction
after sleep instruction
(A)
Figure 6.2 Operation in Power-Down Mode Transitions
Rev. 7.00 Sep. 11, 2009 Page 93 of 566
REJ09B0211-0700