HD6417750RF240V Datasheet, PDF (387/606 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 14 Serial Communication Interface (SCI)
Initialization
Start transmission
Read TDRE flag in SSR
No
TDRE = 1
Yes
Write transmit data to TDR and
set MPBT bit in SSR
Clear TDRE flag to 0
No
All data transmitted?
Yes
Read TEND flag in SSR
No
TEND = 1
Yes
No
Break output?
Yes
Clear DR to 0 and set DDR to 1
[1] [1] SCI initialization:
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1, a
[2]
frame of 1s is output, and
transmission is enabled.
[2] SCI status check and transmit
data write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. Set the
MPBT bit in SSR to 0 or 1.
Finally, clear the TDRE flag to 0.
[3] Serial transmission continuation
procedure:
To continue serial transmission,
be sure to read 1 from the TDRE
[3]
flag to confirm that writing is
possible, then write data to TDR,
and then clear the TDRE flag to
0. Checking and clearing of the
TDRE flag is automatic when the
DTC is activated by a transmit
data empty interrupt (TXI)
request, and data is written to
TDR.
[4] Break output at the end of serial
transmission:
To output a break in serial
[4]
transmission, set the port DDR to
1, clear DR to 0, then clear the
TE bit in SCR to 0.
Clear TE bit in SCR to 0
<End>
Figure 14.11 Sample Multiprocessor Serial Transmission Flowchart
Rev. 7.00 Sep. 11, 2009 Page 351 of 566
REJ09B0211-0700