English
Language : 

HD6417750RF240V Datasheet, PDF (131/606 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series
Section 6 PC Break Controller (PBC)
6.4 Usage Notes
6.4.1 Module Stop Mode Setting
PBC operation can be disabled or enabled using the module stop control register. The initial
setting is for PBC operation to be halted. Register access is enabled by clearing module stop
mode. For details, refer to section 20, Power-Down Modes.
6.4.2 PC Break Interrupts
The PC break interrupt is shared by channels A and B. The channel from which the request was
issued must be determined by the interrupt handler.
6.4.3 CMFA and CMFB
The CMFA and CMFB flags are not automatically cleared to 0, so 0 must be written to CMFA or
CMFB after first reading the flag while it is set to 1. If the flag is left set to 1, another interrupt
will be requested after interrupt handling ends.
6.4.4 PC Break Interrupt when DTC is Bus Master
A PC break interrupt generated when the DTC is the bus master is accepted after the bus has been
transferred to the CPU by the bus controller.
6.4.5
PC Break Set for Instruction Fetch at Address Following BSR, JSR, JMP, TRAPA,
RTE, or RTS Instruction
When a PC break is set for an instruction fetch at an address following a BSR, JSR, JMP, TRAPA,
RTE, or RTS instruction:
Even if the instruction at the address following a BSR, JSR, JMP, TRAPA, RTE, or RTS
instruction is fetched, it is not executed, and so a PC break interrupt is not generated by the
instruction fetch at the next address.
6.4.6 I Bit Set by LDC, ANDC, ORC, or XORC Instruction
When the I bit is set by an LDC, ANDC, ORC, or XORC instruction, a PC break interrupt
becomes valid two states after the end of the executing instruction. If a PC break interrupt is set
for the instruction following one of these instructions, since interrupts, including NMI, are
disabled for a 3-state period in the case of LDC, ANDC, ORC, and XOR, the next instruction is
always executed. For details, see section 5, Interrupt Controller.
Rev. 7.00 Sep. 11, 2009 Page 95 of 566
REJ09B0211-0700