SH7709S Datasheet, PDF (592/807 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

In serial reception, the SCIF operates as described below.
1. The SCIF monitors the transmission line, and if a 0 start bit is detected, performs internal
synchronization and starts reception.
2. The received data is stored in SCRSR in LSB-to-MSB order.
3. The parity bit and stop bit are received.
After receiving these bits, the SCIF carries out the following checks.
a. Stop bit check: The SCIF checks whether the stop bit is 1. If there are two stop bits, only
the first is checked.
b. The SCIF checks whether receive data can be transferred from the receive shift register
(SCRSR) to SCFRDR.
c. Break check: The SCIF checks that the BRK flag is 0, indicating that the break state is not
set.
If all the above checks are passed, the receive data is stored in SCFRDR.
Note: Reception is not suspended when a receive error occurs.
4. If the RIE bit in SCSR is set to 1 when the RDF or DR flag changes to 1, a receive-FIFO-data-
full interrupt (RXI) request is generated.
If the RIE bit in SCSR is set to 1 when the ER flag changes to 1, a receive-error interrupt (ERI)
request is generated.
If the RIE bit in SCSR is set to 1 when the BRK flag changes to 1, a break reception interrupt
(BRI) request is generated.
Rev. 5.00, 09/03, page 548 of 760