SH7709S Datasheet, PDF (230/807 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer Super RISC engine Family/SH7700 Series

Bit 4—Module Stop 7 (MSTP7): Specifies halting of the clock supply to the DMAC (an on-chip
peripheral module). When the MSTP7 bit is set to 1, the supply of the clock to the DMAC is
halted.
Bit 4: MSTP7
0
1
Description
DMAC runs
Clock supply to DMAC halted
(Initial value)
Bit 3—Module Stop 6 (MSTP6): Specifies halting of the clock supply to the DAC (an on-chip
peripheral module). When the MSTP6 bit is set to 1, the supply of the clock to the DAC is halted.
Bit 3: MSTP6
0
1
Description
DAC runs
Clock supply to DAC halted
(Initial value)
Bit 2—Module Stop 5 (MSTP5): Specifies halting of the clock supply to the ADC (an on-chip
peripheral module). When the MSTP5 bit is set to 1, the supply of the clock to the ADC is halted
and all registers are initialized.
Bit 2: MSTP5
0
1
Description
ADC runs
Clock supply to ADC halted and all registers initialized
(Initial value)
Bit 1—Module Stop 4 (MSTP4): Specifies halting of the clock supply to the SCI2 (SCIF) serial
communication interface with FIFO (an on-chip peripheral module). When the MSTP1 bit is set to
1, the supply of the clock to SCI2 (SCIF) is halted.
Bit 1: MSTP4
0
1
Description
SCI2 (SCIF) runs
Clock supply to SCI2 (SCIF) halted
(Initial value)
Bit 0—Module Stop 3 (MSTP3): Specifies halting of the clock supply to the SCI1 (IrDA)
Infrared Data Association interface with FIFO (an on-chip peripheral module). When the MSTP3
bit is set to 1, the supply of the clock to SCI1 (IrDA) is halted.
Bit 0: MSTP3
0
1
Description
SCI1(IrDA) runs
Clock supply to SCI1(IrDA) halted
(Initial value)
Rev. 5.00, 09/03, page 186 of 760