SH7052 Datasheet, PDF (92/919 Pages) Renesas Technology Corp – SuperHTM RISC engine

Power-On Reset Initiated by WDT: When a setting is made for a power-on reset to be generated
in the WDT’s watchdog timer mode, and the WDT’s TCNT overflows, the chip enters the power-
on reset state.
The pin function controller (PFC) registers and I/O port registers are not initialized by the reset
signal generated by the WDT (these registers are only initialized by a power-on reset from off-
chip).
If reset caused by the input signal at the RES pin and a reset caused by WDT overflow occur
simultaneously, the RES pin reset has priority, and the WOVF bit in RSTCSR is cleared to 0.
When WDT-initiated power-on reset processing is started, the CPU operates as follows:
1. The initial value (execution start address) of the program counter (PC) is fetched from the
exception processing vector table.
2. The initial value of the stack pointer (SP) is fetched from the exception processing vector table.
3. The vector base register (VBR) is cleared to H'00000000 and the interrupt mask bits (I3-I0) of
the status register (SR) are set to H'F (1111).
4. The values fetched from the exception processing vector table are set in the PC and SP, and the
program begins executing.
5.2.3 Manual Reset
When a setting is made for a manual reset to be generated in the WDT’s watchdog timer mode,
and the WDT’s TCNT overflows, the chip enters the power-on reset state.
When WDT-initiated manual reset processing is started, the CPU operates as follows:
1. The initial value (execution start address) of the program counter (PC) is fetched from the
exception processing vector table.
2. The initial value of the stack pointer (SP) is fetched from the exception processing vector table.
3. The vector base register (VBR) is cleared to H'00000000 and the interrupt mask bits (I3-I0) of
the status register (SR) are set to H'F (1111).
4. The values fetched from the exception processing vector table are set in the PC and SP, and the
program begins executing.
In a manual reset the bus cycle is retained, but if a manual reset occurs while the bus is released or
during DMAC burst transfer, manual reset exception processing will be deferred until the CPU
acquires the bus. However, if the interval from generation of the manual reset until the end of the
bus cycle is equal to or longer than the internal manual reset interval of 512 cycles, the internal
manual reset source is ignored instead of being deferred, and manual reset exception processing is
not executed.
66