English
Language : 

SH7052 Datasheet, PDF (441/919 Pages) Renesas Technology Corp – SuperHTM RISC engine
12.1.4 Register Configuration
Table 12.2 summarizes the three WDT registers. They are used to select the clock, switch the
WDT mode, and control the reset signal.
Table 12.2 WDT Registers
Address
Name
Abbreviation R/W
Initial Value Write*1
Read*2
Timer control/status TCSR
register
R/(W)*3 H'18
H'FFFFEC10 H'FFFFEC10
Timer counter
TCNT
R/W
H'00
H'FFFFEC11
Reset control/status RSTCSR
register
R/(W)*3 H'1F
H'FFFFEC12 H'FFFFEC13
Notes: 1. Write by word transfer. These registers cannot be written in byte or longword.
2. Read by byte transfer. These registers cannot be read in word or longword.
3. Only 0 can be written to bit 7 to clear the flag.
4. In register access, three cycles are required for both byte access and word access.
12.2 Register Descriptions
12.2.1 Timer Counter (TCNT)
TCNT is an 8-bit readable/writable upcounter. (TCNT differs from other registers in that it is more
difficult to write to. See section 12.2.4, Register Access, for details.) When the timer enable bit
(TME) in the timer control/status register (TCSR) is set to 1, the watchdog timer counter starts
counting pulses of an internal clock selected by clock select bits 2 to 0 (CKS2 to CKS0) in TCSR.
When the value of TCNT overflows (changes from H'FF to H'00), a watchdog timer overflow
signal (WDTOVF) or interval timer interrupt (ITI) is generated, depending on the mode selected
in the WT/IT bit of TCSR.
TCNT is initialized to H'00 by a power-on reset, in hardware and software standby modes, and
when the TME bit is cleared to 0.
Bit: 7
6
5
4
3
2
1
0
Initial value: 0
0
0
0
0
0
0
0
R/W: R/W R/W R/W R/W R/W R/W R/W R/W
415