SH7052 Datasheet, PDF (186/919 Pages) Renesas Technology Corp – SuperHTM RISC engine

1st and 2nd bus
cycles
DMAC
SAR3
Memory
DAR3
Temporary
buffer
Data
buffer
Transfer source
module
Transfer destination
module
The SAR3 value is taken as the address, memory data is read, and the value is stored in the
temporary buffer. Since the value read at this time is used as the address, it must be 32 bits.
If the data bus is 16 bits wide when the external memory space is accessed, two bus cycles
are necessary.
3rd bus cycle
DMAC
SAR3
Memory
DAR3
Temporary
buffer
Data
buffer
Transfer source
module
Transfer destination
module
The value in the temporary buffer is taken as the address, and data is read from the
transfer source module to the data buffer.
4th bus cycle
DMAC
SAR3
Memory
DAR3
Temporary
buffer
Data
buffer
Transfer source
module
Transfer destination
module
The DAR3 value is taken as the address, and the value in the data buffer is written to the
transfer destination module.
Note: Memory, transfer source, and transfer destination modules are shown here.
In practice, connection can be made as long as it is within the address space.
Figure 9.5 Dual Address Mode and Indirect Address Operation (16-Bit-Width External
Memory Space)
160