SH7052 Datasheet, PDF (451/919 Pages) Renesas Technology Corp – SuperHTM RISC engine

12.4.4 System Reset by WDTOVF Signal
If a WDTOVF signal is input to the RES pin, the chip cannot initialize correctly.
Avoid logical input of the WDTOVF output signal to the RES input pin. To reset the entire system
with the WDTOVF signal, use the circuit shown in figure 12.9.
Reset input
SH7052F, SH7053F, SH7054F
RES
Reset signal to
entire system
WDTOVF
Figure 12.9 Example of System Reset Circuit Using WDTOVF Signal
12.4.5 Internal Reset in Watchdog Timer Mode
If the RSTE bit is cleared to 0 in watchdog timer mode, the chip will not be reset internally when a
TCNT overflow occurs, but TCNT and TCSR in the WDT will be reset.
12.4.6 Manual Reset in Watchdog Timer
When an internal reset is effected by TCNT overflow in watchdog timer mode, the processor waits
until the end of the bus cycle at the time of manual reset generation before making the transition to
manual reset exception processing. Therefore, the bus cycle is retained in a manual reset, but if a
manual reset occurs while the bus is released or during DMAC burst transfer, manual reset
exception processing will be deferred until the CPU acquires the bus. However, if the interval
from generation of the manual reset until the end of the bus cycle is equal to or longer than the
internal manual reset interval of 512 cycles, the internal manual reset source is ignored instead of
being deferred, and manual reset exception processing is not executed.
425