SH7619 Datasheet, PDF (564/836 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7619 Series

Section 17 Host Interface (HIF)
DTRG bit
DPOL bit
HIFDREQ
HIFCS
HIFRS
Asserted in synchronization with the
DTRG bit being set by the on-chip CPU.
The DTRG bit is cleared
simultaneously with
HIFDREQ negate.
Negated when HIFCS = HIFRS = low level.
Latency is tPCYC (peripheral clock cycle) × 3 cyc or less.
Figure 17.8 HIFDREQ Timing (When DMD = 0 and DPOL = 0)
When the external DMAC is specified to detect high level of the HIFDREQ signal, set DMD = 0
and DPOL = 1. At the time the DPOL bit is set to 1, HIFDREQ becomes low. Then after writing 1
to the DTRG bit, HIFDREQ remains high until low level is detected for both the HIFCS and
HIFRS signals.
In this case, when the HIFDREQ signal is used, make sure that the setup time (HIFCS assertion to
HIFRS settling) and the hold time (HIFRS hold to HIFCS negate) are satisfied. If t_HIFAS and t_HIFAH
stipulated in section 25.4.11, HIF Timing, are not satisfied, the HIFDREQ signal may be negated
unintentionally.
DTRG bit
DPOL bit
Negated in synchronization
with the DPOL bit being set
by the on-chip CPU.
HIFDREQ
HIFCS
HIFRS
Asserted in synchronization
with the DTRG bit being set
by the on-chip CPU.
The DTRG bit is cleared
simultaneously with
HIFDREQ negate.
Negated when HIFCS = HIFRS = low level.
Latency is tPCYC (peripheral clock cycle) × 3 cyc or less.
Figure 17.9 HIFDREQ Timing (When DMD = 0 and DPOL = 1)
Rev. 5.00 Mar. 15, 2007 Page 526 of 794
REJ09B0237-0500