MC912D60ACPVE8 Datasheet, PDF (399/460 Pages) Freescale Semiconductor, Inc – MC68HC912D60A MC68HC912D60C MC68HC912D60P Technical Data

Development Support
Breakpoints
BK0ALE — Breakpoint 0 Range Control
Valid in all modes.
0 = BRKAL will not be used to compare to the address bus.
1 = BRKAL will be used to compare to the address bus.
Table 19-10. Breakpoint Address Range Control
BK1ALE
–
–
0
1
BK0ALE
Address Range Selected
0 Upper 8-bit address only for full mode or dual mode BKP0
1 Full 16-bit address for full mode or dual mode BKP0
– Upper 8-bit address only for dual mode BKP1
– Full 16-bit address for dual mode BKP1
Bit 7
6
5
0
BKDBE BKMBH
RESET:
0
0
0
BRKCT1 — Breakpoint Control Register 1
4
BKMBL
0
3
BK1RWE
0
2
BK1RW
0
1
BK0RWE
0
Bit 0
BK0RW
0
$0021
This register is read/write in all modes.
BKDBE — Enable Data Bus
Enables comparing of address or data bus values using the BRKDH/L
registers.
0 = The BRKDH/L registers are not used in any comparison
1 = The BRKDH/L registers are used to compare address or data
(depending upon the mode selections BKEN1,0)
BKMBH — Breakpoint Mask High
Disables the comparing of the high byte of data when in full breakpoint
mode. Used in conjunction with the BKDBE bit (which should be set)
0 = High byte of data bus (bits 15:8) are compared to BRKDH
1 = High byte is not used in comparisons
MC68HC912D60A — Rev. 3.1
Freescale Semiconductor
Development Support
Technical Data
399