MC912D60ACPVE8 Datasheet, PDF (290/460 Pages) Freescale Semiconductor, Inc – MC68HC912D60A MC68HC912D60C MC68HC912D60P Technical Data

Freescale Interconnect Bus
violates the rules of Manchester biphase encoding. Up to eight slave
devices may be addressed by the MI Bus. Other features of MI Bus
include message validation, error detection, and default value setting.
On the MC68HC912D60A the MI Bus module shares the same pins on
port S as the SCI0 module. Data is transmitted (or ‘pushed’) via the TxD0
pin, and received (‘pulled’) via the RxD0 pin. While data is being pushed,
RxD0 will be disconnected from the receiver circuitry. The message
frame is handled automatically in hardware. The MCU register interface
is similar to that for the SCI.
16.3 Push-pull sequence
Communication between the MCU and the slave device always utilizes
the same frame organization. First, the MCU sends serial data to the
selected device. This data field is called the ‘push field’. At the end of the
push field, the selected device automatically sends back to the MCU the
data held during the push sequence. The MCU reads the serial data sent
by the selected device. This data is called the ‘pull field’ and contains
status information followed by the end-of-frame information from the
selected device.
Time slots
Push-pull function
TxD0 pin (true data)
MI Bus wire
Bit fields
Push (biphase coded)
Pull (NRZ coded)
10
01
01234567
Start
Stop
Start
Push
sync
D0
D1
D2
D3
D4
A0
A1
A2
Pull
sync
Data
Address
Push field
(driven by MCU)
Message frame
NRZ
Data
End of frame
Pull field
(driven by slave)
Figure 16-1. MI Bus timing
Technical Data
290
Freescale Interconnect Bus
MC68HC912D60A — Rev. 3.1
Freescale Semiconductor