MC912D60ACPVE8 Datasheet, PDF (384/460 Pages) Freescale Semiconductor, Inc – MC68HC912D60A MC68HC912D60C MC68HC912D60P Technical Data

Development Support
Table 19-2. Hardware Commands⁽¹⁾
Command
BACKGROUND
READ_BD_BYTE⁽¹⁾
READ_BD_WORD⁽¹⁾
READ_BYTE
READ_WORD
WRITE_BD_BYTE⁽¹⁾
WRITE_BD_WORD⁽¹⁾
WRITE_BYTE
WRITE_WORD
Opcode
(Hex)
90
E4
EC
E0
E8
C4
CC
C0
C8
Data
Description
None
16-bit address
16-bit data out
16-bit address
16-bit data out
16-bit address
16-bit data out
16-bit address
16-bit data out
16-bit address
16-bit data in
16-bit address
16-bit data in
16-bit address
16-bit data in
16-bit address
16-bit data in
Enter background mode if firmware enabled.
Read from memory with BDM in map (may steal
cycles if external access) data for odd address on
low byte, data for even address on high byte.
Read from memory with BDM in map (may steal
cycles if external access). Must be aligned access.
Read from memory with BDM out of map (may steal
cycles if external access) data for odd address on
low byte, data for even address on high byte.
Read from memory with BDM out of map (may steal
cycles if external access). Must be aligned access.
Write to memory with BDM in map (may steal cycles
if external access) data for odd address on low
byte, data for even address on high byte.
Write to memory with BDM in map (may steal cycles
if external access). Must be aligned access.
Write to memory with BDM out of map (may steal
cycles if external access) data for odd address on
low byte, data for even address on high byte.
Write to memory with BDM out of map (may steal
cycles if external access). Must be aligned access.
1. Use these commands only for reading/writing to BDM locations.The BDM firmware ROM and BDM registers are not nor-
mally in the HC12 MCU memory map.Since these locations have the same addresses as some of the normal application
memory map, there needs to be a way to decide which physical locations are being accessed by the hardware BDM
commands.This gives rise to needing separate memory access commands for the BDM locations as opposed to the
normal application locations.In logic, this is accomplished by momentarily enabling the BDM memory resources, just for
the access cycles of the READ_BD and WRITE_BD commands.This logic allows the debugging system to unobtrusively
access the BDM locations even if the application program is running out of the same memory area in the normal appli-
cation memory map.
The second type of BDM commands are firmware commands
implemented in a small ROM within the HC12 MCU. The CPU must be
in background mode to execute firmware commands. The usual way to
get to background mode is by the hardware command BACKGROUND.
The BDM ROM is located at $FF20 to $FFFF while BDM is active. There
are also seven bytes of BDM registers located at $FF00 to $FF06 when
BDM is active. The CPU executes code in the BDM firmware to perform
the requested operation. The BDM firmware watches for serial
commands and executes them as they are received. The firmware
commands are shown in Table 19-3.
Technical Data
384
Development Support
MC68HC912D60A — Rev. 3.1
Freescale Semiconductor