English
Language : 

XR72L52 Datasheet, PDF (453/480 Pages) Exar Corporation – TWO CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER
xr
TWO CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER
XRT72L52
REV. 1.0.1
TABLE 88: LISTING AND DESCRIPTION OF THE PIN ASSOCIATED WITH THE RECEIVE PAYLOAD DATA OUTPUT
INTERFACE BLOCK
SIGNAL NAME TYPE
DESCRIPTION
RxSer
Output
Receive Serial Payload Data Output pin:
If the user opts to operate the XRT72L52 in the serial mode, then the chip will output the pay-
load data, of the incoming E3 frames, via this pin. The XRT72L52 will output this data upon
the rising edge of RxClk.
The user is advised to design the Terminal Equipment such that it will sample this data on the
rising edge of RxClk.
NOTE: This signal is only active if the NibIntfinput pin is pulled "Low".
RxNib[3:0]
Output
Receive Nibble-Parallel Payload Data Output pins:
If the user opts to operate the XRT72L52 in the nibble-parallel mode, then the chip will output
the payload data, of the incoming E3 frames, via these pins. The XRT72L52 will output data
via these pins, upon the falling edge of the RxClk output pin.
The user is advised to design the Terminal Equipment such that it will sample this data upon
the rising edge of RxClk.
NOTE: These pins are only active if the NibIntfinput pin is pulled "High".
RxClk
Output
Receive Payload Data Output Clock pin:
The exact behavior of this signal depends upon whether the XRT72L52 is operating in the
Serial or in the Nibble-Parallel-Mode.
Serial Mode Operation
In the serial mode, this signal is a 34.368MHz clock output signal. The Receive Payload Data
Output Interface will update the data via the RxSer output pin, upon the rising edge of this
clock signal.
The user is advised to design (or configure) the Terminal Equipment to sample the data on the
RxSer pin, upon the falling edge of this clock signal.
Nibble-Parallel Mode Operation
In this Nibble-Parallel Mode, the XRT72L52 will derive this clock signal, from the RxLineClk
signal. The XRT72L52 will pulse this clock 1060 times for each Inbound E3 frame. The
Receive Payload Data Output Interface will update the data, on the RxNib[3:0] output pins
upon the falling edge of this clock signal.
The user is advised to design (or configure) the Terminal Equipment to sample the data on the
RxNib[3:0] output pins, upon the rising edge of this clock signal
RxOHInd
Output
Receive Overhead Bit Indicator Output:
This output pin will pulse "High" whenever the Receive Payload Data Output Interface outputs
an overhead bit via the RxSer output pin. The purpose of this output pin is to alert the Termi-
nal Equipment that the current bit, (which is now residing on the RxSer output pin), is an over-
head bit and should not be processed by the Terminal Equipment.
The XRT72L52 will update this signal, upon the rising edge of RxOHInd.
The user is advised to design (or configure) the Terminal Equipment to sample this signal
(along with the data on the RxSer output pin) on the falling edge of the RxClk signal.
NOTE: For E3 applications, this output pin is only active if the XRT72L52 is operating in the
Serial Mode. This output pin will be "Low" if the device is operating in the Nibble-Parallel
Mode.
437