XR72L52 Datasheet, PDF (331/480 Pages) Exar Corporation – TWO CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER

xr
TWO CHANNEL DS3/E3 FRAMER IC WITH HDLC CONTROLLER
XRT72L52
REV. 1.0.1
RXE3 LAPD STATUS REGISTER (ADDRESS = 0X19)
BIT 7
Not Used
BIT 6
RxABORT
RO
RO
0
0
BIT 5
BIT 4
RxLAPDType[1:0]
RO
RO
0
0
BIT 3
RxCR
Type
RO
0
BIT 2
RxFCS
Error
RO
0
BIT 1
End of
Message
RO
0
BIT 0
Flag
Present
RO
0
Table 59 presents the relationship between the contents of RxLAPDType[1:0] and the type of message re-
ceived by the LAPD Receiver.
TABLE 59: THE RELATIONSHIP BETWEEN THE CONTENTS OF RXLAPDTYPE[1:0] BIT-FIELDS AND THE PMDL
MESSAGE TYPE/SIZE
RXLAPDTYPE[1:0] PMDL MESSAGE TYPE
00
CL Path Identification
01
Idle Signal Identification
10
Test Signal Identification
11
ITU-T Path Identification
PMDL MESSAGE SIZE
76 Bytes
76 Bytes
76 Bytes
82 Bytes
NOTE: Prior to reading in the PMDL Message from the Receive LAPD Message buffer, the user is urged to read the state
of the RxLAPDType[1:0] bit-fields in order to determine the size of this message.
5. Inform the Local Microprocessor/External Circuitry of the receipt of the new LAPD Message frame.
Finally, after the LAPD Receiver has received and processed the newly received LAPD Message frame (per
steps 1 through 4, as described above), it will inform the local Microprocessor that a LAPD Message frame has
been received and is ready for user-system handling. The LAPD Receiver will inform the Microprocessor/Mi-
crocontroller and the external circuitry by:
• Generating a LAPD Message Frame Received interrupt to the Microprocessor. The purpose of this interrupt
is to let the Microprocessor know that the Receive LAPD Message buffer contains a new PMDL Message
that needs to be read and processed. When the LAPD Receiver generates this interrupt, it will set bit 0
(RxLAPD Interrupt Status) within the Rx E3 LAPD Control Register to “1” as depicted below.
)
RXE3 LAPD CONTROL REGISTER (ADDRESS = 0X18
BIT 7
RO
0
BIT 6
BIT 5
Not Used
BIT 4
RO
RO
RO
0
0
0
BIT 3
RO
0
BIT 2
RxLAPD
Enable
R/W
0
BIT 1
BIT 0
RxLAPD
RxLAPD
Interrupt Enable Interrupt Status
R/W
RUR
0
1
• Setting Bit 1 (End of Message) within the Rx E3 LAPD Status Register, to “1” as depicted below.
315