M32C80 Datasheet, PDF (248/352 Pages) Renesas Technology Corp – 16/32-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M32C/80 SERIES

M32C/80 Group
17. A/D Converter
17.1.3 Single Sweep Mode
In single sweep mode, analog voltage that is applied to selected pins is converted one-by-one to a digital
code. Table 17.4 lists specifications of single sweep mode.
Table 17.4 Single Sweep Mode Specifications
Item
Specification
Function
The SCAN1 and SCAN0 bits in the AD0CON1 register select pins. Analog voltage
applied to the pin is converted one-by-one to a digital code
Start Condition
Same as one-shot mode
Stop Condition
Same as one-shot mode
Interrupt Request Generation Timing • When the DUS bit in the AD0CON3 register is set to "0" (DMAC operating
mode disabled), an interrupt request is generated after a sweep is completed.
• When DUS bit is set to "1" (DMAC operating mode enabled), an interrupt
request is generated every time an A/D conversion is completed
Analog Voltage Input Pins
Select from AN0 and AN1 (2 pins), AN0 to AN3 (4 pins), AN0 to AN5 (6 pins) or AN0
to AN7 (8 pins)
Reading of A/D Conversion Result • When the DUS bit is set to "0", the microcomputer reads the AD0j register (j=0 to
7) corresponding to selected pins
• When DUS bit is set to "1", do not read the AD00 register. A/D conversion result
is stored in the AD00 register after the A/D conversion is completed. DMAC
transfers the conversion result to any memory space. Refer to 12. DMAC for
DMAC settings
Rev. 1.00 Nov. 01, 2005 Page 229 of 330
REJ09B0271-0100