XRT74L73 Datasheet, PDF (286/488 Pages) Exar Corporation – 3 CHANNEL, ATM UNI/PPP DS3/E3 FRAMING CONTROLLER

XRT74L73
3 CHANNEL, ATM UNI/PPP DS3/E3 FRAMING CONTROLLER
REV. P1.0.1
PRELIMINARY
stored the contents of this message in the Receive
LAPD Message Buffer.
Enabling/Disable the Receive LAPD Message In-
terrupt
To enable or disable the Receive LAPD Message In-
terrupt, write the appropriate data into Bit 1 (RxLAPD
Interrupt Enable) within the RxDS3 LAPD Control
Register, as indicated below.
RXDS3 LAPD CONTROL REGISTER (ADDRESS = 0X18)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Not Used
RxLAPD
Enable
RxLAPD
Interrupt
Enable
RxLAPD
Interrupt
Status
RO
RO
RO
RO
RO
R/W
R/W
RUR
0
0
0
0
0
0
X
0
Writing a “1” into this bit-field enables the Receive
LAPD Message Interrupt. Conversely, writing a “0”
into this bit-field disables the Receive LAPD Message
interrupt.
Servicing the Receive LAPD Message Interrupt
Whenever the XRT74L73 Framer IC generates this
interrupt, it will do the following.
• It will assert the Interrupt Request output pin (INT)
by driving it "Low".
• It will set Bit 0 (RxLAPD Interrupt Status), within the
Rx DS3 LAPD Control Register to “1”, as indicated
below.
RXDS3 LAPD CONTROL REGISTER (ADDRESS = 0X18)
BIT 7
BIT 6
BIT 5
BIT 4
BIT 3
BIT 2
BIT 1
BIT 0
Not Used
RxLAPD
Enable
RxLAPD
Interrupt
Enable
RxLAPD
Interrupt
Status
RO
RO
RO
RO
RO
R/W
R/W
RUR
0
0
0
0
0
0
1
1
• It will write the contents of this newly Received
LAPD Message into the Receive LAPD Message
buffer (located at 0xDE through 0x135).
Whenever the Terminal Equipment encounters the
Receive LAPD Interrupt, then it should read out the
contents of the Receive LAPD Message buffer, and
respond accordingly.
287