SA1110 Datasheet, PDF (95/406 Pages) Intel Corporation – Intel StrongARM SA-1110 Microprocessor

System Control Module
9.4.5
OS Timer Interrupt Enable Register (OIER)
This register contains four enable bits indicating whether a match between one of the match
registers and the OS timer counter will set a status bit in the OSSR. Each match register has a
corresponding enable bit. Clearing an enable bit does not clear the corresponding interrupt status
bit if that bit is already set.
0h 9000 001C
OIER
Read/Write
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Reserved
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bits
0
1
2
3
31..4
Name
E0
E1
E2
E3
—
Description
Interrupt enable channel 0.
This bit is set by software and allows a match between match register OSMR[0] and the OS
timer to assert interrupt bit M0 in the OSSR.
Interrupt enable channel 1.
This bit is set by software and allows a match between match register OSMR[1] and the OS
timer to assert interrupt bit M1 in the OSSR.
Interrupt enable channel 2.
This bit is set by software and allows a match between match register OSMR[2] and the OS
timer to assert interrupt bit M2 in the OSSR.
Interrupt enable channel 3.
This bit is set by software and allows a match between match register OSMR[3] and the OS
timer to assert interrupt bit M3 in the OSSR.
Reserved
9.4.6
Watchdog Timer
OSMR 3 may also serve as a watchdog compare register. This function is enabled by setting bit 0 in
the OWER. When a compare against this register occurs when the watchdog is enabled, reset is
applied to the SA-1110 and most internal states are cleared (with exceptions listed below). Internal
reset is asserted for 256 processor clocks and then removed, allowing the SA-1110 to boot. Units
that do not receive this internal reset are: the power manager, the refresh timer, and the PLL
configuration. Watchdog reset affects the SA-1110 similar to a software reset. See the Section 9.6,
“Reset Controller” on page 9-42 for details on what is affected by each kind of reset. When the
SA-1110 comes out of a watchdog reset, a bit is set in the reset controller status register (RCSR) to
indicate that the event happened.
The following procedure is suggested when using OSMR 3 as a watchdog: each time the operating
system services the register, the current value of the counter is read, and a number is then added to
the value read, corresponding to the amount of time before the next timeout (care must be taken to
account for counter wrap–around). This number is then written back to OSMR 3. The OS code
must repeat this procedure periodically before each match occurs. If the match occurs, the OS timer
will assert a reset.
SA-1110 Developer’s Manual
9-25