SA1110 Datasheet, PDF (73/406 Pages) Intel Corporation – Intel StrongARM SA-1110 Microprocessor

System Control Module
9.1.1.1 GPIO Pin-Level Register (GPLR)
The state of each of the GPIO port pins is visible through the GPIO pin-level register (GPLR).
Each bit number corresponds to the port pin number from bit 0 to bit 27. This is a read-only register
that is used to determine the current level of a particular pin (regardless of the programmed pin
direction).
The following table shows the locations of the 28 pin-level bits within the GPLR. This is a
read-only register. For reserved bits, reads return zero; a question mark indicates that the values are
unknown at reset.
.
0h 9004 0000
GPLR
Read-Only
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Reserved
Reset 0 0 0 0 ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?
Bits
n
31..28
Name
PLn
—
Description
GPIO port pin level n (where n = 0 through 27).
0 – Pin state is low.
1 – Pin state is high
Reserved
Note: A question mark (?) signifies that the Reset value of that bit is undefined when the processor has
completed its reset cycle.
SA-1110 Developer’s Manual
9-3