HD64F2357F20V Datasheet, PDF (657/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

19.16 Register Descriptions
19.16.1 Flash Memory Control Register 1 (FLMCR1)
Bit
:
7
6
5
4
3
2
1
0
FWE SWE
ESU
PSU
EV
PV
E
P
Initial value :
1
0
0
0
0
0
0
0
R/W
:
R
R/W
R/W
R/W
R/W
R/W
R/W
R/W
FLMCR1 is an 8-bit register used for flash memory operating mode control. Program-verify mode or erase-verify mode is
entered by setting SWE to 1, then setting the EV or PV bit. Program mode is entered by setting SWE to 1, then setting the
PSU bit, and finally setting the P bit. Erase mode is entered by setting SWE to 1, then setting the ESU bit, and finally
setting the E bit. FLMCR1 is initialized to H'80 by a reset, and in hardware standby mode and software standby mode.
When on-chip flash memory is disabled, a read will return H'00, and writes are invalid.
Writing to bits ESU, PSU, EV, and PV in FLMCR1 is enabled only when SWE = 1; writing to the E bit is enabled only
when SWE = 1, and ESU = 1; and writing to the P bit is enabled only when SWE = 1, and PSU = 1.
Bit 7—Flash Write Enable Bit (FWE): Sets hardware protection against flash memory programming/erasing. These bits
cannot be modified and are always read as 1 in this model.
Bit 6—Software Write Enable Bit (SWE): Enables or disables flash memory programming and erasing. This bit should
be set when setting bits 5 to 0, EBR1 bits 7 to 0, and EBR2 bits 3 to 0.
When SWE = 1, the flash memory can only be read in program-verify or erase-verify mode.
Bit 6
SWE
0
1
Description
Writes disabled
Writes enabled
(Initial value)
Bit 5—Erase Setup Bit (ESU): Prepares for a transition to erase mode. Do not set the SWE, PSU, EV, PV, E, or P bit at
the same time.
Bit 5
ESU
Description
0
Erase setup cleared
(Initial value)
1
Erase setup
[Setting condition]
When SWE = 1
Bit 4—Program Setup Bit (PSU): Prepares for a transition to program mode. Do not set the SWE, ESU, EV, PV, E, or P
bit at the same time.
Bit 4
PSU
0
1
Description
Program setup cleared
Program setup
[Setting condition]
When SWE = 1
(Initial value)
Rev.6.00 Oct.28.2004 page 627 of 1016
REJ09B0138-0600H