 English |
|
|
|
|
|
|
|
| HD64F2357F20V Datasheet, PDF (602/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series | |||
| |||
| ◁ |
Address
Data
VPP
VPP
VCC
VCC
VCC+1
VCC
CE
PGM
OE
Program
tAS
Input data
tDS
tDH
tVPS
tVCS
tCES
tPW
tOPW*
tOES
Verify
tAH
Output data
tDF
tOE
Note: * tOPW is defined by the value shown in the flowchart.
Figure 19-5 PROM Programming/Verification Timing
19.5.3 Programming Precautions
⢠Program using the specified voltages and timing.
The programming voltage (VPP) in PROM mode is 12.5 V.
If the PROM programmer is set to Renesas Technology HN27C101 specifications, VPP will be 12.5 V. Applied
voltages in excess of the specified values can permanently destroy the MCU. Be particularly careful about the PROM
programmerâs overshoot characteristics.
⢠Before programming, check that the MCU is correctly mounted in the PROM programmer. Overcurrent damage to the
MCU can result if the index marks on the PROM programmer, socket adapter, and MCU are not correctly aligned.
⢠Do not touch the socket adapter or MCU while programming. Touching either of these can cause contact faults and
programming errors.
⢠The MCU cannot be programmed in page programming mode. Select the programming mode carefully.
⢠The size of the H8S/2357 PROM is 128 kbytes. Always set addresses within the range H'00000 to H'1FFFF. During
programming, write H'FF to unused addresses to avoid verification errors.
Rev.6.00 Oct.28.2004 page 572 of 1016
REJ09B0138-0600H
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese