HD64F2357F20V Datasheet, PDF (476/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

12.4 Interrupts
12.4.1 Interrupt Sources and DTC Activation
There are three 8-bit timer interrupt sources: CMIA, CMIB, and OVI. Their relative priorities are shown in table 12-3.
Each interrupt source is set as enabled or disabled by the corresponding interrupt enable bit in TCR, and independent
interrupt requests are sent for each to the interrupt controller. It is also possible to activate the DTC by means of CMIA
and CMIB interrupts.
Table 12-3 8-Bit Timer Interrupt Sources
Channel
Interrupt Source Description
DTC Activation
Priority
0
CMIA0
Interrupt by CMFA Possible
High
CMIB0
Interrupt by CMFB Possible
OVI0
Interrupt by OVF
Not possible
1
CMIA1
Interrupt by CMFA Possible
CMIB1
Interrupt by CMFB Possible
OVI1
Interrupt by OVF
Not possible
Low
Note: This table shows the initial state immediately after a reset. The relative channel priorities can be changed by the
interrupt controller.
12.4.2 A/D Converter Activation
The A/D converter can be activated only by channel 0 compare match A.
If the ADTE bit in TCSR0 is set to 1 when the CMFA flag is set to 1 by the occurrence of channel 0 compare match A, a
request to start A/D conversion is sent to the A/D converter. If the 8-bit timer conversion start trigger has been selected on
the A/D converter side at this time, A/D conversion is started.
Rev.6.00 Oct.28.2004 page 446 of 1016
REJ09B0138-0600H