HD64F2357F20V Datasheet, PDF (300/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

Port 1 Data Direction Register (P1DDR)
Bit
:
7
6
5
4
3
2
1
0
P17DDR P16DDR P15DDR P14DDR P13DDR P12DDR P11DDR P10DDR
Initial value :
0
0
0
0
0
0
0
0
R/W
:W
W
W
W
W
W
W
W
P1DDR is an 8-bit write-only register, the individual bits of which specify input or output for the pins of port 1. P1DDR
cannot be read; if it is, an undefined value will be read.
Setting a P1DDR bit to 1 makes the corresponding port 1 pin an output pin, while clearing the bit to 0 makes the pin an
input pin.
P1DDR is initialized to H'00 by a power-on reset, and in hardware standby mode. It retains its prior state after a manual
reset*, and in software standby mode. As the PPG, TPU, and DMAC are initialized by a manual reset*, the pin states are
determined by the P1DDR and P1DR specifications.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Port 1 Data Register (P1DR)
Bit
:
Initial value :
R/W
:
7
P17DR
0
R/W
6
P16DR
0
R/W
5
P15DR
0
R/W
4
P14DR
0
R/W
3
P13DR
0
R/W
2
P12DR
0
R/W
1
P11DR
0
R/W
0
P10DR
0
R/W
P1DR is an 8-bit readable/writable register that stores output data for the port 1 pins (P1₇ to P1₀).
P1DR is initialized to H'00 by a power-on reset, and in hardware standby mode. It retains its prior state after a manual
reset*, and in software standby mode.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Port 1 Register (PORT1)
Bit
:
7
6
5
4
3
2
1
0
P17
P16
P15
P14
P13
P12
P11
P10
Initial value : —*
—*
—*
—*
—*
—*
—*
—*
R/W
:
R
R
R
R
R
R
R
R
Note: * Determined by state of pins P1₇ to P1₀.
PORT1 is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of output data for the port 1
pins (P1₇ to P1₀) must always be performed on P1DR.
If a port 1 read is performed while P1DDR bits are set to 1, the P1DR values are read. If a port 1 read is performed while
P1DDR bits are cleared to 0, the pin states are read.
After a power-on reset and in hardware standby mode, PORT1 contents are determined by the pin states, as P1DDR and
P1DR are initialized. PORT1 retains its prior state after a manual reset*, and in software standby mode.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Rev.6.00 Oct.28.2004 page 270 of 1016
REJ09B0138-0600H