HD64F2357F20V Datasheet, PDF (325/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Port 5 Data Register (P5DR)
Bit
:
7
6
5
4
3
—
—
—
— P53DR
Initial value : Undefined Undefined Undefined Undefined 0
R/W
:—
—
—
—
R/W
2
P52DR
0
R/W
1
P51DR
0
R/W
0
P50DR
0
R/W
P5DR is an 8-bit readable/writable register that stores output data for the port 5 pins (P5₃ to P5₀).
Bits 7 to 4 are reserved; they return an undetermined value if read, and cannot be modified.
P5DR is initialized to H'0 (bits 3 to 0) by a power-on reset, and in hardware standby mode. It retains its prior state after a
manual reset*, and in software standby mode.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Port 5 Register (PORT5)
Bit
:
7
6
5
4
3
2
1
0
—
—
—
—
P53
P52
P51
P50
Initial value : Undefined Undefined Undefined Undefined —*
—*
—*
—*
R/W
:—
—
—
—
R
R
R
R
Note: * Determined by state of pins P5₃ to P5₀.
PORT5 is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of output data for the port 5
pins (P5₃ to P5₀) must always be performed on P5DR.
Bits 7 to 4 are reserved; they return an undetermined value if read, and cannot be modified.
If a port 5 read is performed while P5DDR bits are set to 1, the P5DR values are read. If a port 5 read is performed while
P5DDR bits are cleared to 0, the pin states are read.
After a power-on reset and in hardware standby mode, PORT5 contents are determined by the pin states, as P5DDR and
P5DR are initialized. PORT5 retains its prior state after a manual reset*, and in software standby mode.
Note: * Manual reset is only supported in the H8S/2357 ZTAT.
Rev.6.00 Oct.28.2004 page 295 of 1016
REJ09B0138-0600H