HD64F2357F20V Datasheet, PDF (222/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

7.4.2 DMA Terminal Control Register (DMATCR)
Bit
:
7
6
5
4
3
2
1
0
DMATCR : —
—
TEE1 TEE0
—
—
—
—
Initial value :
0
0
0
0
0
0
0
0
R/W
:—
—
R/W
R/W
—
—
—
—
DMATCR is an 8-bit readable/writable register that controls enabling or disabling of DMAC transfer end pin output. A
port can be set for output automatically, and a transfer end signal output, by setting the appropriate bit.
DMATCR is initialized to H'00 by a reset, and in standby mode.
Bits 7 and 6—Reserved: These bits cannot be modified and are always read as 0.
Bit 5—Transfer End Enable 1 (TEE1): Enables or disables transfer end pin 1 (TEND1) output.
Bit 5
TEE1
0
1
Description
TEND1 pin output disabled
TEND1 pin output enabled
(Initial value)
Bit 4—Transfer End Enable 0 (TEE0): Enables or disables transfer end pin 0 (TEND0) output.
Bit 4
TEE0
0
1
Description
TEND0 pin output disabled
TEND0 pin output enabled
(Initial value)
The TEND pins are assigned only to channel B in short address mode.
The transfer end signal indicates the transfer cycle in which the transfer counter reached 0, regardless of the transfer
source. An exception is block transfer mode, in which the transfer end signal indicates the transfer cycle in which the
block counter reached 0.
Bits 3 to 0—Reserved: These bits cannot be modified and are always read as 0.
Rev.6.00 Oct.28.2004 page 192 of 1016
REJ09B0138-0600H