HD64F2357F20V Datasheet, PDF (463/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

Section 12 8-Bit Timers
12.1 Overview
The H8S/2357 Group includes an 8-bit timer module with two channels (TMR0 and TMR1). Each channel has an 8-bit
counter (TCNT) and two time constant registers (TCORA and TCORB) that are constantly compared with the TCNT
value to detect compare match events. The 8-bit timer module can thus be used for a variety of functions, including pulse
output with an arbitrary duty cycle.
12.1.1 Features
The features of the 8-bit timer module are listed below.
• Selection of four clock sources
The counters can be driven by one of three internal clock signals (ø/8, ø/64, or ø/8192) or an external clock input
(enabling use as an external event counter).
• Selection of three ways to clear the counters
The counters can be cleared on compare match A or B, or by an external reset signal.
• Timer output control by a combination of two compare match signals
The timer output signal in each channel is controlled by a combination of two independent compare match signals,
enabling the timer to generate output waveforms with an arbitrary duty cycle or PWM output.
• Provision for cascading of two channels
 Operation as a 16-bit timer is possible, using channel 0 for the upper 8 bits and channel 1 for the lower 8 bits (16-
bit count mode).
 Channel 1 can be used to count channel 0 compare matches (compare match count mode).
• Three independent interrupts
Compare match A and B and overflow interrupts can be requested independently.
• A/D converter conversion start trigger can be generated
Channel 0 compare match A signal can be used as an A/D converter conversion start trigger.
• Module stop mode can be set
 As the initial setting, 8-bit timer operation is halted. Register access is enabled by exiting module stop mode.
Rev.6.00 Oct.28.2004 page 433 of 1016
REJ09B0138-0600H