HD64F2357F20V Datasheet, PDF (115/1049 Pages) Renesas Technology Corp – Hardware Manual Renesas 16-Bit Single-chip Microcomputer H8S Family / H8S/2300 Series

Table 5-3 Correspondence between Interrupt Sources and IPR Settings
Bits
Register
6 to 4
2 to 0
IPRA
IRQ0
IRQ1
IPRB
IRQ2
IRQ3
IRQ4
IRQ5
IPRC
IRQ6
IRQ7
DTC
IPRD
Watchdog timer
Refresh timer
IPRE
—*
A/D converter
IPRF
TPU channel 0
TPU channel 1
IPRG
TPU channel 2
TPU channel 3
IPRH
TPU channel 4
TPU channel 5
IPRI
8-bit timer channel 0
8-bit timer channel 1
IPRJ
DMAC
SCI channel 0
IPRK
SCI channel 1
SCI channel 2
Note: * Reserved bits. These bits cannot be modified and are always read as 1.
As shown in table 5-3, multiple interrupts are assigned to one IPR. Setting a value in the range from H'0 to H'7 in the 3-bit
groups of bits 6 to 4 and 2 to 0 sets the priority of the corresponding interrupt. The lowest priority level, level 0, is
assigned by setting H'0, and the highest priority level, level 7, by setting H'7.
When interrupt requests are generated, the highest-priority interrupt according to the priority levels set in the IPR registers
is selected. This interrupt level is then compared with the interrupt mask level set by the interrupt mask bits (I2 to I0) in
the extend register (EXR) in the CPU, and if the priority level of the interrupt is higher than the set mask level, an interrupt
request is issued to the CPU.
5.2.3 IRQ Enable Register (IER)
Bit
:
Initial value :
R/W
:
7
IRQ7E
0
R/W
6
IRQ6E
0
R/W
5
IRQ5E
0
R/W
4
IRQ4E
0
R/W
3
IRQ3E
0
R/W
2
IRQ2E
0
R/W
1
IRQ1E
0
R/W
0
IRQ0E
0
R/W
IER is an 8-bit readable/writable register that controls enabling and disabling of interrupt requests IRQ7 to IRQ0.
IER is initialized to H'00 by a reset and in hardware standby mode.
Bits 7 to 0—IRQ7 to IRQ0 Enable (IRQ7E to IRQ0E): These bits select whether IRQ7 to IRQ0 are enabled or
disabled.
Bit n
IRQnE
0
1
Description
IRQn interrupts disabled
IRQn interrupts enabled
(Initial value)
(n = 7 to 0)
Rev.6.00 Oct.28.2004 page 85 of 1016
REJ09B0138-0600H