MC68HC908AT32 Datasheet, PDF (211/378 Pages) Freescale Semiconductor, Inc – Microcontrollers

I/O Signals
19.7 I/O Signals
Port D shares one of its pins with the TIMB. Port F shares two of its pins with the TIMB.
PTD4/ATD12/TBCLK is an external clock input to the TIMB prescaler. The two TIMB channel I/O pins are
PTF4/TBCH0 and PTF5/TBCH1.
19.7.1 TIMB Clock Pin (PTD4/ATD12/TBCLK)
PTD4/ATD12/TBCLK is an external clock input that can be the clock source for the TIMB counter instead
of the prescaled internal bus clock. Select the PTD4/ATD12/TBCLK input by writing logic 1s to the three
prescaler select bits, PS[2:0]. (See 19.8.1 TIMB Status and Control Register.) The minimum TCLK pulse
width, TCLK_LMIN or TCLK_HMIN, is:
------------------1-------------------
bus frequency
+
tSU
The maximum TCLK frequency is the least: 4 MHz or bus frequency ÷ 2.
PTD4/ATD12/TBCLK is available as a general-purpose I/O pin or ADC channel when not used as the
TIMB clock input. When the PTD6/ATD14/TACLK pin is the TIMB clock input, it is an input regardless of
the state of the DDRD6 bit in data direction register D.
19.7.2 TIMB Channel I/O Pins (PTF5/TBCH1–PTF4/TBCH0)
Each channel I/O pin is programmable independently as an input capture pin or an output compare pin.
PTF4/TBCH0 and PTF5/TBCH1 can be configured as buffered output compare or buffered PWM pins.
19.8 I/O Registers
These I/O registers control and monitor TIMB operation:
• TIMB status and control register (TBSC)
• TIMB control registers (TBCNTH–TBCNTL)
• TIMB counter modulo registers (TBMODH–TBMODL)
• TIMB channel status and control registers (TBSC0 and TBSC1)
• TIMB channel registers (TBCH0H–TBCH0L and TBCH1H–TBCH1L)
19.8.1 TIMB Status and Control Register
The TIMB status and control register:
• Enables TIMB overflow interrupts
• Flags TIMB overflows
• Stops the TIMB counter
• Resets the TIMB counter
• Prescales the TIMB counter clock
MC68HC908AT32 Data Sheet, Rev. 3.1
Freescale Semiconductor
211