MC68HC908AT32 Datasheet, PDF (196/378 Pages) Freescale Semiconductor, Inc – Microcontrollers

Timer Interface (TIMA-4)
TOIE — TIMA Overflow Interrupt Enable Bit
This read/write bit enables TIMA overflow interrupts when the TOF bit becomes set. Reset clears the
TOIE bit.
1 = TIMA overflow interrupts enabled
0 = TIMA overflow interrupts disabled
TSTOP — TIMA Stop Bit
This read/write bit stops the TIMA counter. Counting resumes when TSTOP is cleared. Reset sets the
TSTOP bit, stopping the TIMA counter until software clears the TSTOP bit.
1 = TIMA counter stopped
0 = TIMA counter active
NOTE
Do not set the TSTOP bit before entering wait mode if the TIMA is required
to exit wait mode. Also when the TSTOP bit is set and the timer is
configured for input capture operation, input captures are inhibited until the
TSTOP bit is cleared.
TRST — TIMA Reset Bit
Setting this write-only bit resets the TIMA counter and the TIMA prescaler. Setting TRST has no effect
on any other registers. Counting resumes from $0000. TRST is cleared automatically after the TIMA
counter is reset and always reads as logic 0. Reset clears the TRST bit.
1 = Prescaler and TIMA counter cleared
0 = No effect
NOTE
Setting the TSTOP and TRST bits simultaneously stops the TIMA counter
at a value of $0000.
PS[2:0] — Prescaler Select Bits
These read/write bits select either the PTD6/ATD14/TACLK pin or one of the seven prescaler outputs
as the input to the TIMA counter as Table 18-1 shows. Reset clears the PS[2:0] bits.
PS[2:0]
000
001
010
011
100
101
110
111
Table 18-1. Prescaler Selection
TIMA Clock Source
Internal bus clock ÷1
Internal bus clock ÷ 2
Internal bus clock ÷ 4
Internal bus clock ÷ 8
Internal bus clock ÷ 16
Internal bus clock ÷ 32
Internal bus clock ÷ 64
PTD6/ATD14/TACLK
MC68HC908AT32 Data Sheet, Rev. 3.1
196
Freescale Semiconductor