MC68HC908AT32 Datasheet, PDF (199/378 Pages) Freescale Semiconductor, Inc – Microcontrollers

I/O Registers
When CHxIE = 0, clear CHxF by reading TIMA channel x status and control register with CHxF set,
and then writing a logic 0 to CHxF. If another interrupt request occurs before the clearing sequence is
complete, then writing logic 0 to CHxF has no effect. Therefore, an interrupt request cannot be lost due
to inadvertent clearing of CHxF.
Reset clears the CHxF bit. Writing a logic 1 to CHxF has no effect.
1 = Input capture or output compare on channel x
0 = No input capture or output compare on channel x
CHxIE — Channel x Interrupt Enable Bit
This read/write bit enables TIMA CPU interrupts on channel x.
Reset clears the CHxIE bit.
1 = Channel x CPU interrupt requests enabled
0 = Channel x CPU interrupt requests disabled
MSxB — Mode Select Bit B
This read/write bit selects buffered output compare/PWM operation. MSxB exists only in the TIMA
channel 0 and TIMA channel 2 status and control registers.
Setting MS0B disables the channel 1 status and control register and reverts TACH1 pin to
general-purpose I/O.
Setting MS2B disables the channel 3 status and control register and reverts TACH3 pin to
general-purpose I/O.
Reset clears the MSxB bit.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation.
(See Table 18-2.)
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
When ELSxB:A = 00, this read/write bit selects the initial output level of the TCHx pin once PWM, input
capture, or output compare operation is enabled. (See Table 18-2.). Reset clears the MSxA bit.
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIMA status and control register (TASC).
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
MC68HC908AT32 Data Sheet, Rev. 3.1
Freescale Semiconductor
199