MC68HC908AT32 Datasheet, PDF (151/378 Pages) Freescale Semiconductor, Inc – Microcontrollers

SCI during Break Module Interrupts
16.5.2 Stop Mode
The SCI module is inactive in stop mode. The STOP instruction does not affect SCI register states. SCI
module operation resumes after the MCU exits stop mode.
Because the internal clock is inactive during stop mode, entering stop mode during an SCI transmission
or reception results in invalid data.
16.6 SCI during Break Module Interrupts
The BCFE bit in the break flag control register (BFCR) enables software to clear status bits during the
break state. See Chapter 11 Break Module (BRK).
To allow software to clear status bits during a break interrupt, write a logic 1 to the BCFE bit. If a status
bit is cleared during the break state, it remains cleared when the MCU exits the break state.
To protect status bits during the break state, write a logic 0 to the BCFE bit. With BCFE at logic 0 (its
default state), software can read and write I/O registers during the break state without affecting status bits.
Some status bits have a 2-step read/write clearing procedure. If software does the first step on such a bit
before the break, the bit cannot change during the break state as long as BCFE is at logic 0. After the
break, doing the second step clears the status bit.
16.7 I/O Signals
Port E shares two of its pins with the SCI module. The two SCI I/O pins are:
• PTE0/SCTxD — Transmit data
• PTE1/SCRxD — Receive data
16.7.1 PTE0/SCTxD (Transmit Data)
The PTE0/SCTxD pin is the serial data output from the SCI transmitter. The SCI shares the PTE0/SCTxD
pin with port E. When the SCI is enabled, the PTE0/SCTxD pin is an output regardless of the state of the
DDRE2 bit in data direction register E (DDRE).
16.7.2 PTE1/SCRxD (Receive Data)
The PTE1/SCRxD pin is the serial data input to the SCI receiver. The SCI shares the PTE1/SCRxD pin
with port E. When the SCI is enabled, the PTE1/SCRxD pin is an input regardless of the state of the
DDRE1 bit in data direction register E (DDRE).
16.8 I/O Registers
These I/O registers control and monitor SCI operation:
• SCI control register 1 (SCC1)
• SCI control register 2 (SCC2)
• SCI control register 3 (SCC3)
• SCI status register 1 (SCS1)
• SCI status register 2 (SCS2)
• SCI data register (SCDR)
• SCI baud rate register (SCBR)
MC68HC908AT32 Data Sheet, Rev. 3.1
Freescale Semiconductor
151