EP4CE30F29C7N Datasheet, PDF (424/488 Pages) Altera Corporation – Cyclone IV Device Handbook, Volume 1

3–26
Chapter 3: Cyclone IV Dynamic Reconfiguration
Dynamic Reconfiguration Modes
Table 3–5. rx_dataoutfull[31..0] FPGA Fabric-Transceiver Channel Interface Signal Descriptions (Part 3 of 3)
FPGA Fabric-Transceiver Channel Receive Signal Description (Based on Cyclone IV GX Supported FPGA
Interface Description
Fabric-Transceiver Channel Interface Widths)
Two 10-bit Data (rx_dataout)
rx_dataoutfull[9:0] - rx_dataout (LSByte) and rx_dataoutfull[25:16] -
rx_dataout (MSByte)
wo Receiver Sync Status Bits
rx_dataoutfull[10] - rx_syncstatus (LSB) and rx_dataoutfull[26] -
rx_syncstatus (MSB)
20-bit FPGA fabric-Transceiver
Channel Interface with PCS-PMA
set to 10 bits
rx_dataoutfull[11] and rx_dataoutfull[27]: 8B/10B disparity error indicator
(rx_disperr)
Two Receiver Pattern Detect Bits
rx_dataoutfull[12] - rx_patterndetect (LSB) and rx_dataoutfull[28] -
rx_patterndetect (MSB)
rx_dataoutfull[13] and rx_dataoutfull[29]: Rate Match FIFO deletion status
indicator (rx_rmfifodatadeleted) in non-PCI Express (PIPE) functional modes
rx_dataoutfull[14] and rx_dataoutfull[30]: Rate Match FIFO insertion status
indicator (rx_rmfifodatainserted) in non-PCI Express (PIPE) functional modes
rx_dataoutfull[15] and rx_dataoutfull[31]: 8B/10B running disparity
indicator (rx_runningdisp)
Data Rate Reconfiguration Mode Using RX Local Divider
The RX local divider resides in the RX PMA block for every channels. This is a
hardware feature where a /2 divider is available in each of the receiver channel for the
supported device. You can use this RX local divider to reconfigure the data rate at the
receiver channel. This can be used for protocols such as SDI that has data rates in
divisions of 2.
By using this RX local divider, you can support two different data rates without using
additional transceiver PLLs. This dynamic reconfiguration mode is available only for
the receiver and not applicable to the transmitter. This reconfiguration mode using the
RX local divider (/2) is only supported and available in EP4CGX30 (F484 package),
EP4CGX50, and EP4CGX75 devices.
f For more information about this RX local divider, refer to the Cyclone IV GX
Transceiver Architecture chapter.
Cyclone IV Device Handbook,
Volume 2
November 2011 Altera Corporation