EP4CE30F29C7N Datasheet, PDF (403/488 Pages) Altera Corporation – Cyclone IV Device Handbook, Volume 1

Chapter 3: Cyclone IV Dynamic Reconfiguration
3–5
Dynamic Reconfiguration Controller Port List
Table 3–2. Dynamic Reconfiguration Controller Port List (ALTGX_RECONFIG Instance) (Part 2 of 7)
Port Name
Input/
Output
Description
FPGA Fabric and ALTGX_RECONFIG Interface Signals
Assert this signal for one reconfig_clk clock cycle to initiate a write transaction from the
ALTGX_RECONFIG instance to the ALTGX instance.
You can use this signal in two ways for .mif-based modes:
write_all
Input
■ Continuous write operation—select the Enable continuous write of all the words
needed for reconfiguration option to pulse the write_all signal only once for writing
a whole .mif. The What is the read latency of the MIF contents option is available for
selection in this case only. Enter the desired latency in terms of the reconfig_clk
cycles.
■ Regular write operation—when the Enable continuous write of all the words needed
for reconfiguration option is disabled, every word of the .mif requires its own write
cycle.
This signal is used to indicate the busy status of the dynamic reconfiguration controller
during offset cancellation. After the device powers up, this signal remains low for the first
reconfig_clk clock cycle. It then is asserted and remains high when the dynamic
reconfiguration controller performs offset cancellation on all the receiver channels
connected to the ALTGX_RECONFIG instance.
busy
Output ^{Deassertion of the busy signal indicates the successful completion of the offset}
cancellation process.
■ PMA controls reconfiguration mode—this signal is high when the dynamic
reconfiguration controller performs a read or write transaction.
■ Channel reconfiguration modes—this signal is high when the dynamic reconfiguration
controller writes the .mif into the transceiver channel.
read
Input
Assert this signal for one reconfig_clk clock cycle to initiate a read transaction. The
read port is applicable only to the PMA controls reconfiguration mode. The read port is
available when you select Analog controls in the Reconfiguration settings screen and
select at least one of the PMA control ports in the Analog controls screen.
Applicable only to PMA controls reconfiguration mode. This port indicates the validity of
the data read from the transceiver by the dynamic reconfiguration controller.
data_valid
Output The data on the output read ports is valid only when the data_valid is high.
This signal is enabled when you enable at least one PMA control port used in read
transactions, for example tx_vodctrl_out.
error
Output
This indicates that an unsupported operation was attempted. You can select this in the
Error checks screen. The dynamic reconfiguration controller deasserts the busy signal and
asserts the error signal for two reconfig_clk cycles when you attempt an unsupported
operation. For more information, refer to “Error Indication During Dynamic
Reconfiguration” on page 3–36.
November 2011 Altera Corporation
Cyclone IV Device Handbook,
Volume 2