EP4CE30F29C7N Datasheet, PDF (174/488 Pages) Altera Corporation – Cyclone IV Device Handbook, Volume 1

8–10
Chapter 8: Configuration and Remote System Upgrades in Cyclone IV Devices
Configuration
1 For Cyclone IV E devices, the Quartus II software prohibits you from using the LVDS
I/O standard in I/O Bank 1 when the configuration device I/O voltage is not 2.5 V. If
you need to assign LVDS I/O standard in I/O Bank 1, navigate to
Assignments>Device>Settings>Device and Pin Option>Configuration to change
the Configuration Device I/O voltage to 2.5 V or Auto.
AS Configuration (Serial Configuration Devices)
In the AS configuration scheme, Cyclone IV devices are configured with a serial
configuration device. These configuration devices are low-cost devices with
non-volatile memories that feature a simple four-pin interface and a small form factor.
These features make serial configuration devices the ideal low-cost configuration
solution.
f For more information about serial configuration devices, refer to the Serial
Configuration Devices (EPCS1, EPCS4, EPCS16, EPCS64, and EPCS128) Datasheet in
volume 2 of the Configuration Handbook.
Serial configuration devices provide a serial interface to access the configuration data.
During device configuration, Cyclone IV devices read the configuration data through
the serial interface, decompress the data if necessary, and configure their SRAM cells.
This scheme is referred to as the AS configuration scheme because the device controls
the configuration interface.
1 If you want to gain control of the EPCS pins, hold the nCONFIG pin low and pull the
nCE pin high to cause the device to reset and tri-state the AS configuration pins.
Single-Device AS Configuration
The four-pin interface of serial configuration devices consists of the following pins:
■ Serial clock input (DCLK)
■ Serial data output (DATA)
■ Active-low chip select (nCS)
■ AS data input (ASDI)
Cyclone IV Device Handbook,
Volume 1
May 2013 Altera Corporation