EP4CE30F29C7N Datasheet, PDF (355/488 Pages) Altera Corporation – Cyclone IV Device Handbook, Volume 1

Chapter 1: Cyclone IV Transceivers Architecture
Transceiver Functional Modes
1–75
Figure 1–67 shows the transceiver configuration in Deterministic Latency mode.
Figure 1–67. Transceiver Configuration in Deterministic Latency Mode
Functional Mode
Deterministic Latency
Channel Bonding
×1, ×4
Low-Latency PCS
Disabled
Word Aligner (Pattern Length)
Manual Alignment
(10-Bit)
Bit Slip
(10-Bit)
8B/10B Encoder/Decoder
Enabled
Disabled
Enabled
Disabled
Rate Match FIFO
Disabled
Disabled
Disabled
Disabled
Byte SERDES
Enabled Disabled
Enabled Disabled Enabled Disabled
Enabled Disabled
Data Rate (Gbps)
Byte Ordering
FPGA Fabric-to-Transceiver
Interface Width
FPGA Fabric-to-Transceiver
Interface Frequency (MHz)
TX PCS Latency (FPGA
Fabric-Transceiver Interface
Clock Cycles)
RX PCS Latency (FPGA
Fabric-Transceiver Interface
Clock Cycles)
0.6-
3.125
0.6-
1.5625
0.6-
3.125
0.6-
1.5625
0.6-
3.125
0.6-
1.5625
0.6-
3.125
0.6-
1.5625
Disabled Disabled
Disabled Disabled Disabled Disabled
Disabled Disabled
16-Bit
8-Bit
20-Bit
10-Bit
16-Bit
8-Bit
20-Bit
10-Bit
60-
156.25
30-
156.25
60-
156.25
30-
156.25
60-
156.25
30-
156.25
60-
156.25
30-
156.25
2.5 - 3.5
4-5
2.5 - 3.5
4-5
2.5 - 3
4
2.5 - 3
4
5-6
8-9
5-6
8-9
5-6
8-9
5-6
8-9
Both CPRI and OBSAI protocols define the serial interface connecting the base station
component (specifically channel cards) and remote radio heads (specifically radio
frequency cards) in a radio base station system with fiber optics. The protocols require
the accuracy of round trip delay measurement for single-hop and multi-hop
connections to be within ± 16.276 ns. The Cyclone IV GX transceivers support the
following CPRI and OBSAI line rates using Deterministic Latency mode:
■ CPRI —614.4 Mbps, 1.2288 Gbps, 2.4576 Gbps, and 3.072 Gbps
■ OBSAI—768 Mbps, 1.536 Gbps, and 3.072 Gbps
f For more information about deterministic latency implementation, refer to AN 610:
Implementing Deterministic Latency for CPRI and OBSAI Protocols in Stratix IV, HardCopy
IV, Arria II GX, and Cyclone IV Devices.
Registered Mode Phase Compensation FIFO
In Deterministic Latency mode, the RX phase compensation FIFO is set to registered
mode while the TX phase compensation FIFO supports optional registered mode.
When set into registered mode, the phase compensation FIFO acts as a register and
eliminates the latency uncertainty through the FIFOs.
October 2013 Altera Corporation
Cyclone IV Device Handbook,
Volume 2