EP4CE30F29C7N Datasheet, PDF (219/488 Pages) Altera Corporation – Cyclone IV Device Handbook, Volume 1

Chapter 8: Configuration and Remote System Upgrades in Cyclone IV Devices
Configuration
8–55
Programming Serial Configuration Devices In-System with the JTAG Interface
Cyclone IV devices in a single- or multiple-device chain support in-system
programming of a serial configuration device with the JTAG interface through the SFL
design. The intelligent host or download cable of the board can use the four JTAG pins
on the Cyclone IV device to program the serial configuration device in system, even if
the host or download cable cannot access the configuration pins (DCLK, DATA, ASDI, and
nCS pins).
The SFL design is a JTAG-based in-system programming solution for Altera serial
configuration devices. The SFL is a bridge design for the Cyclone IV device that uses
their JTAG interface to access the EPCS JTAG Indirect Configuration Device
Programming (.jic) file and then uses the AS interface to program the EPCS device.
Both the JTAG interface and AS interface are bridged together inside the SFL design.
In a multiple device chain, you must only configure the master device that controls
the serial configuration device. Slave devices in the multiple device chain that are
configured by the serial configuration device do not have to be configured when
using this feature. To successfully use this feature, set the MSEL pins of the master
device to select the AS configuration scheme (Table 8–3 on page 8–8, Table 8–4 on
page 8–8, and Table 8–5 on page 8–9). The serial configuration device in-system
programming through the Cyclone IV device JTAG interface has three stages, which
are described in the following sections:
■ “Loading the SFL Design”
■ “ISP of the Configuration Device” on page 8–56
■ “Reconfiguration” on page 8–57
Loading the SFL Design
The SFL design is a design inside the Cyclone IV device that bridges the JTAG
interface and AS interface with glue logic.
The intelligent host uses the JTAG interface to configure the master device with a SFL
design. The SFL design allows the master device to control the access of four serial
configuration device pins, also known as the Active Serial Memory Interface (ASMI)
pins, through the JTAG interface. The ASMI pins are serial clock input (DCLK), serial
data output (DATA), AS data input (ASDI), and active-low chip select (nCS) pins.
May 2013 Altera Corporation
Cyclone IV Device Handbook,
Volume 1