EP4CE30F29C7N Datasheet, PDF (317/488 Pages) Altera Corporation – Cyclone IV Device Handbook, Volume 1

Chapter 1: Cyclone IV Transceivers Architecture
Transceiver Clocking Architecture
1–37
Bonded Channel Configuration
In bonded channel configuration, the low-speed clock for the bonded channels share a
common bonded clock path that reduces clock skew between the bonded channels.
The phase compensation FIFOs in bonded channels share a set of pointers and control
logic that results in equal FIFO latency between the bonded channels. These features
collectively result in lower channel-to-channel skew when implementing
multi-channel serial interface in bonded channel configuration.
In a transceiver block, the high-speed clock for each bonded channels is distributed
independently from one of the two multipurpose PLLs directly adjacent to the block.
The low-speed clock for bonded channels is distributed from a common bonded clock
path that selects from one of the two multipurpose PLLs directly adjacent to the block.
Transceiver channels for devices in F484 and larger packages support additional
clocking flexibility for ×2 bonded channels. In these packages, the ×2 bonded channels
support high-speed and low-speed bonded clock distribution from PLLs beyond the
two multipurpose PLLs directly adjacent to the block. Table 1–10 lists the high- and
low-speed clock sources for the bonded channels.
Table 1–10. High- and Low-Speed Clock Sources for Bonded Channels in Bonded Channel
Configuration
Package
F324 and smaller
Transceiver
Block
GXBL0
Bonded Channels
×2 in channels 0, 1
×4 in all channels
High- and Low-Speed Clocks Source
Option 1
Option 2
MPLL_1
MPLL_2
F484 and larger
GXBL0
GXBL1 (1)
×2 in channels 0, 1
×4 in all channels
×2 in channels 0, 1
×4 in all channels
Note to Table 1–10:
(1) GXBL1 is not available for transceivers in F484 package.
MPLL_5/
GPLL_1
MPLL_5
MPLL_7/
MPLL_6
MPLL_7
MPLL_6
MPLL_6
MPLL_8
MPLL_8
1 When implementing ×2 bonded channel configuration in a transceiver block,
remaining channels 2 and 3 are available to implement other non-bonded channel
configuration.
October 2013 Altera Corporation
Cyclone IV Device Handbook,
Volume 2