SH7606 Datasheet, PDF (412/532 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7606 Series

Section 16 User Break Controller (UBC)
Initial
Bit
Bit Name Value R/W Description
13
SCMFDA 0
R/W I Bus Cycle Condition Match Flag A
When the I bus cycle condition in the break conditions set
for channel A is satisfied, this flag is set to 1 (not cleared
to 0). In order to clear this flag, write 0 into this bit.
0: The I bus cycle condition for channel A does not match
1: The I bus cycle condition for channel A matches
12
SCMFDB 0
R/W I Bus Cycle Condition Match Flag B
When the I bus cycle condition in the break conditions set
for channel B is satisfied, this flag is set to 1 (not cleared
to 0). In order to clear this flag, write 0 into this bit.
0: The I bus cycle condition for channel B does not match
1: The I bus cycle condition for channel B matches
11
PCTE
0
R/W PC Trace Enable
0: Disables PC trace
1: Enables PC trace
10
PCBA 0
R/W PC Break Select A
Selects the break timing of the instruction fetch cycle for
channel A as before or after instruction execution.
0: PC break of channel A is set before instruction
execution
1: PC break of channel A is set after instruction execution
9, 8
—
All 0 R
Reserved
These bits are always read as 0. The write value should
always be 0.
7
DBEB 0
R/W Data Break Enable B
Selects whether or not the data bus condition is included
in the break condition of channel B.
0: No data bus condition is included in the condition of
channel B
1: The data bus condition is included in the condition of
channel B
Rev. 4.00 Sep. 13, 2007 Page 386 of 502
REJ09B0239-0400