English
Language : 

SH7606 Datasheet, PDF (125/532 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7606 Series
Section 6 Interrupt Controller (INTC)
IRQSR.IRQnL
IRQCR.IRQn1S IRQSR.IRQnF
IRQCR.IRQn0S
IRQn pins
Level
detection
Edge
detection
SQ
CPU interrupt
request
R
RESIRQn
(Acceptance of IRQn interrupt/
writing 0 after reading IRQnF = 1)
n = 7 to 0
Figure 6.2 Block Diagram of IRQ7 to IRQ0 Interrupts Control
6.4.2 On-Chip Peripheral Module Interrupts
On-chip peripheral module interrupts are interrupts generated by the following on-chip peripheral
modules.
Since a different interrupt vector is allocated to each interrupt source, the exception handling
routine does not have to decide which interrupt has occurred. Priority levels between 0 and 15 can
be allocated to individual on-chip peripheral modules in interrupt priority registers C to E (IPRC
to IPRE). On-chip peripheral module interrupt exception handling sets the interrupt mask level
bits (I3 to I0) in the status register (SR) to the priority level value of the on-chip peripheral module
interrupt that was accepted.
6.4.3 User Break Interrupt
A user break interrupt has a priority level of 15, and occurs when the break condition set in the
user break controller (UBC) is satisfied. User break interrupt requests are detected by edge and are
held until accepted. User break interrupt exception handling sets the interrupt mask level bits (I3
to I0) in the status register (SR) to level 15. For more details on the user break interrupt, see
section 16, User Break Controller (UBC).
Rev. 4.00 Sep. 13, 2007 Page 99 of 502
REJ09B0239-0400