SH7606 Datasheet, PDF (193/532 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7606 Series

Section 7 Bus State Controller (BSC)
Burst Write: A burst write occurs in the following cases in this LSI.
1. Access size in writing is larger than data bus width.
2. Write-back of the cache
This LSI always accesses SDRAM with burst length 1. For example, write access of burst length 1
is performed consecutively eight times to write 16-byte consecutive data to the SDRAM that is
connected to a 16-bit data bus. The relationship between the access size and the number of bursts
is shown in table 7.16.
Figure 7.15 shows a timing chart for burst writes. In burst write, the ACTV command is output in
the Tr cycle, the WRIT command is issued in the Tc1, Tc2, and Tc3 cycles, and the WRITA
command is issued to execute an auto-precharge in the Tc4 cycle. In the write cycle, the write data
is output simultaneously with the write command. After the write command with the auto-
precharge is output, the Trw1 cycle that waits for the auto-precharge initiation is followed by the
Tap cycle that waits for completion of the auto-precharge induced by the WRITA command in the
SDRAM. In the Tap cycle, a new command will not be issued to the same bank. However, other
CS areas and other banks can be accessed. The number of Trw1 cycles is specified by bits
TRWL1 and TRWL0 in CS3WCR. The number of Tap cycles is specified by bits WTRP1 and
WTRP0 in CS3WCR.
CKIO
A25 to A0
A11*
CSn
RAS
CAS
RD/WR
DQMxx
D15 to D0
BS
Tr
Tc1
Tc2
Tc3
Tc4 Trwl
Tap
Note: * Address pin to be connected to pin A10 of SDRAM.
Figure 7.15 Basic Timing for Burst Write (Auto Precharge)
Rev. 4.00 Sep. 13, 2007 Page 167 of 502
REJ09B0239-0400