MC68HC912BD32 Datasheet, PDF (78/292 Pages) Freescale Semiconductor, Inc – Advance Information

Flash EEPROM
Freescale Semiconductor, Inc.
Programming the Flash EEPROM
Programming the Flash EEPROM is accomplished by the following
sequence. The V_FP pin voltage must be at the proper level prior to
executing step 4 the first time.
1. Apply program/erase voltage to the V_FP pin.
2. Clear ERAS and set the LAT bit in the FEECTL register to
establish program mode and enable programming address and
data latches.
3. Write data to a valid address. The address and data is latched. If
BOOTP is asserted, an attempt to program an address in the boot
block will be ignored.
4. Apply programming voltage by setting ENPE.
5. Delay for one programming pulse (t_PPULSE).
6. Remove programming voltage by clearing ENPE.
7. Delay while high voltage is turning off (t_VPROG).
8. Read the address location to verify that it has been programmed
9. If the location is not programmed, repeat steps 4 through 7 until
the location is programmed or until the specified maximum
number of program pulses has been reached (n_PP)
10. If the location is programmed, repeat the same number of pulses
as required to program the location. This provides 100% program
margin.
11. Read the address location to verify that it remains programmed.
12. Clear LAT.
13. If there are more locations to program, repeat steps 2 through 10.
14. Turn off V_FP (reduce voltage on V_FP pin to V_DD).
The flowchart in Figure 7 demonstrates the recommended programming
sequence.
MC68HC912BD32 Rev 1.0
Flash EEPROM
For More Information On This Product,
Go to: www.freescale.com
10-flash