MC68HC912BD32 Datasheet, PDF (255/292 Pages) Freescale Semiconductor, Inc – Advance Information

Freescale Semiconductor, Inc.
Development Support
Breakpoints
BK1ALE
–
–
0
1
Table 62 Breakpoint Address Range Control
BK0ALE
0
1
–
–
Address Range Selected
Upper 8-bit address only for full mode or dual mode BKP0
Full 16-bit address for full mode or dual mode BKP0
Upper 8-bit address only for dual mode BKP1
Full 16-bit address for dual mode BKP1
BRKCT1 — Breakpoint Control Register 1
RESET:
Bit 7
0
0
6
BKDBE
0
5
BKMBH
0
4
BKMBL
0
3
BK1RWE
0
2
BK1RW
0
This register is read/write in all modes.
1
BK0RWE
0
Bit 0
BK0RW
0
$0021
BKDBE — Enable Data Bus
Enables comparing of address or data bus values using the BRKDH/L
registers.
0 = The BRKDH/L registers are not used in any comparison
1 = The BRKDH/L registers are used to compare address or data
(depending upon the mode selections BKEN1,0)
BKMBH — Breakpoint Mask High
Disables the comparing of the high byte of data when in full breakpoint
mode. Used in conjunction with the BKDBE bit (which should be set)
0 = High byte of data bus (bits 15:8) are compared to BRKDH
1 = High byte is not used to in comparisons
BKMBL — Breakpoint Mask Low
Disables the matching of the low byte of data when in full breakpoint
mode. Used in conjunction with the BKDBE bit (which should be set)
0 = Low byte of data bus (bits 7:0) are compared to BRKDL
1 = Low byte is not used to in comparisons.
BK1RWE — R/W Compare Enable
Enables the comparison of the R/W signal to further specify what
causes a match. This bit is NOT useful in program breakpoints or in
full breakpoint mode. This bit is used in conjunction with a second
address in dual address mode when BKDBE=1.
0 = R/W is not used in comparisons
21-dev
Development Support
For More Information On This Product,
Go to: www.freescale.com
MC68HC912BD32 Rev 1.0