Z8F4822AR020SG Datasheet, PDF (110/323 Pages) Zilog, Inc. – High Performance 8-Bit Microcontrollers

Z8 Encore! XP^® F64xx Series
Product Specification
90
– Set or clear the CTSE bit to enable or disable control from the remote receiver
using the CTS pin
5. Check the TDRE bit in the UART Status 0 Register to determine if the Transmit Data
Register is empty (indicated by a 1). If empty, continue to Step 6. If the Transmit Data
Register is full (indicated by a 0), continue to monitor the TDRE bit until the Transmit
Data Register becomes available to receive new data.
6. Write the UART Control 1 Register to select the outgoing address bit.
7. Set the MULTIPROCESSOR Bit Transmitter (MPBT) if sending an address byte;
clear it if sending a data byte.
8. Write the data byte to the UART Transmit Data Register. The transmitter automati-
cally transfers the data to the Transmit Shift Register and transmits the data.
9. If appropriate and MULTIPROCESSOR Mode is enabled, make any changes to the
MULTIPROCESSOR Bit Transmitter (MPBT) value.
10. To transmit additional bytes, return to Step 5.
Transmitting Data using the Interrupt-Driven Method
The UART transmitter interrupt indicates the availability of the Transmit Data Register to
accept new data for transmission. Observe the following procedure to configure the UART
for interrupt-driven data transmission:
1. Write to the UART Baud Rate High and Low Byte registers to set the appropriate baud
rate.
2. Enable the UART pin functions by configuring the associated GPIO port pins for
alternate function operation.
3. Execute a DI instruction to disable interrupts.
4. Write to the Interrupt control registers to enable the UART Transmitter interrupt and
set the appropriate priority.
5. If MULTIPROCESSOR Mode is appropriate, write to the UART Control 1 Register to
enable MULTIPROCESSOR (9-Bit) Mode functions.
6. Set the MULTIPROCESSOR Mode Select (MPEN) to Enable MULTIPROCESSOR
Mode.
7. Write to the UART Control 0 Register to:
– Set the transmit enable bit (TEN) to enable the UART for data transmission
– Enable parity, if appropriate and if MULTIPROCESSOR Mode is not enabled,
and select either even or odd parity
PS019924-0113
PRELIMINARY
Operation