MC9S12GRMV1 Datasheet, PDF (912/1292 Pages) Freescale Semiconductor, Inc – MC9S12G Family Reference Manual and Data Sheet

48 KByte Flash Module (S12FTMRG48K1V1)
26.4.6.2 Erase Verify Block Command
The Erase Verify Block command allows the user to verify that an entire P-Flash or EEPROM block has
been erased. The FCCOB FlashBlockSelectionCode[1:0] bits determine which block must be verified.
Table 26-33. Erase Verify Block Command FCCOB Requirements
CCOBIX[2:0]
000
FCCOB Parameters
Flash block
0x02
selection code [1:0]. See
Table 26-34
Table 26-34. Flash block selection code description
Selection code[1:0]
00
01
10
11
Flash block to be verified
EEPROM
Invalid (ACCERR)
Invalid (ACCERR)
P-Flash
Upon clearing CCIF to launch the Erase Verify Block command, the Memory Controller will verify that
the selected P-Flash or EEPROM block is erased. The CCIF flag will set after the Erase Verify Block
operation has completed.If the block is not erased, it means blank check failed, both MGSTAT bits will be
set.
Register
FSTAT
Table 26-35. Erase Verify Block Command Error Handling
Error Bit
ACCERR
FPVIOL
MGSTAT1
MGSTAT0
Error Condition
Set if CCOBIX[2:0] != 000 at command launch
Set if an invalid FlashBlockSelectionCode[1:0] is supplied
None
Set if any errors have been encountered during the read or if blank check failed.
Set if any non-correctable errors have been encountered during the read or if
blank check failed.
26.4.6.3 Erase Verify P-Flash Section Command
The Erase Verify P-Flash Section command will verify that a section of code in the P-Flash memory is
erased. The Erase Verify P-Flash Section command defines the starting point of the code to be verified and
the number of phrases.
MC9S12G Family Reference Manual, Rev.1.23
914
Freescale Semiconductor