MC9S12GRMV1 Datasheet, PDF (864/1292 Pages) Freescale Semiconductor, Inc – MC9S12G Family Reference Manual and Data Sheet

32 KByte Flash Module (S12FTMRG32K1V1)
Table 25-46. Erase Flash Block Command FCCOB Requirements
CCOBIX[2:0]
000
001
FCCOB Parameters
0x09
Global address [17:16] to
identify Flash block
Global address [15:0] in Flash block to be erased
Upon clearing CCIF to launch the Erase Flash Block command, the Memory Controller will erase the
selected Flash block and verify that it is erased. The CCIF flag will set after the Erase Flash Block
operation has completed.
Table 25-47. Erase Flash Block Command Error Handling
Register
FSTAT
Error Bit
ACCERR
FPVIOL
MGSTAT1
MGSTAT0
Error Condition
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see Table 25-27)
Set if an invalid global address [17:16] is supplied
Set if the supplied P-Flash address is not phrase-aligned or if the EEPROM
address is not word-aligned
Set if an area of the selected Flash block is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
25.4.6.9 Erase P-Flash Sector Command
The Erase P-Flash Sector operation will erase all addresses in a P-Flash sector.
Table 25-48. Erase P-Flash Sector Command FCCOB Requirements
CCOBIX[2:0]
000
001
FCCOB Parameters
0x0A
Global address [17:16] to identify
P-Flash block to be erased
Global address [15:0] anywhere within the sector to be erased.
Refer to Section 25.1.2.1 for the P-Flash sector size.
Upon clearing CCIF to launch the Erase P-Flash Sector command, the Memory Controller will erase the
selected Flash sector and then verify that it is erased. The CCIF flag will be set after the Erase P-Flash
Sector operation has completed.
MC9S12G Family Reference Manual, Rev.1.23
866
Freescale Semiconductor