MC9S12GRMV1 Datasheet, PDF (269/1292 Pages) Freescale Semiconductor, Inc – MC9S12G Family Reference Manual and Data Sheet

S12G Memory Map Controller (S12GMMCV1)
Read: Anytime.
Write: Only if a transition is allowed (see Figure 5-4).
The MODC bit of the MODE register is used to select the MCU’s operating mode.
Table 5-4. MODE Field Descriptions
Field
7
MODC
Description
Mode Select Bit — This bit controls the current operating mode during RESET high (inactive). The external
mode pin MODC determines the operating mode during RESET low (active). The state of the pin is registered
into the respective register bit after the RESET signal goes inactive (see Figure 5-4).
Write restrictions exist to disallow transitions between certain modes. Figure 5-4 illustrates all allowed mode
changes. Attempting non authorized transitions will not change the MODE bit, but it will block further writes to
the register bit except in special modes.
Write accesses to the MODE register are blocked when the device is secured.
RESET
1
0
Normal
Single-Chip
1
(NS)
1
Special
Single-Chip
(SS)
0
Figure 5-4. Mode Transition Diagram when MCU is Unsecured
5.3.2.2 Direct Page Register (DIRECT)
Address: 0x0011
R
W
Reset
7
DP15
0
6
DP14
0
5
DP13
0
4
DP12
0
3
DP11
0
2
DP10
0
1
DP9
0
0
DP8
0
Figure 5-5. Direct Register (DIRECT)
Read: Anytime
Write: anytime in special SS, write-once in NS.
This register determines the position of the 256 Byte direct page within the memory map.It is valid for both
global and local mapping scheme.
MC9S12G Family Reference Manual, Rev.1.23
Freescale Semiconductor
271