S912XEG384J3VA Datasheet, PDF (1164/1324 Pages) Freescale Semiconductor, Inc – MC9S12XEP100 Reference Manual Covers MC9S12XE Family

Chapter 29 1024 KByte Flash Module (S12XFTM1024K5V2)
29.3.2.9.1 P-Flash Protection Restrictions
The general guideline is that P-Flash protection can only be added and not removed. Table 29-23 specifies
all valid transitions between P-Flash protection scenarios. Any attempt to write an invalid scenario to the
FPROT register will be ignored. The contents of the FPROT register reflect the active protection scenario.
See the FPHS and FPLS bit descriptions for additional restrictions.
Table 29-23. P-Flash Protection Scenario Transitions
From
To Protection Scenario⁽¹⁾
Protection
Scenario
0
1
2
3
4
5
6
7
0
X
X
X
X
1
X
X
2
X
X
3
X
4
X
X
5
X
X
X
X
6
X
X
X
X
7
X
X
X
X
X
X
X
X
1. Allowed transitions marked with X, see Figure 29-14 for a definition of the scenarios.
29.3.2.10 EEE Protection Register (EPROT)
The EPROT register defines which buffer RAM EEE partition areas are protected against writes.
Offset Module Base + 0x0009
7
6
5
4
R
EPOPEN
W
RNV[6:4]
3
EPDIS
2
1
0
EPS[2:0]
Reset
F
F
F
F
F
F
F
F
= Unimplemented or Reserved
Figure 29-15. EEE Protection Register (EPROT)
All bits in the EPROT register are readable and writable except for RNV[6:4] which are only readable. The
EPOPEN and EPDIS bits can only be written to the protected state. The EPS bits can be written anytime
until the EPDIS bit is cleared. If the EPOPEN bit is cleared, the state of the EPDIS and EPS bits is
irrelevant.
During the reset sequence, the EPROT register is loaded from the EEE protection byte in the Flash
configuration field at global address 0x7F_FF0D located in P-Flash memory (see Table 29-3) as indicated
by reset condition F in Figure 29-15. To change the EEE protection that will be loaded during the reset
sequence, the P-Flash sector containing the EEE protection byte must be unprotected, then the EEE
protection byte must be programmed. If a double bit fault is detected while reading the P-Flash phrase
1164
MC9S12XE-Family Reference Manual Rev. 1.25
Freescale Semiconductor